Electrolux EIDW5905JS - Manual (Page 20)

20
• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a “new” smell when first
installed. This is normal.
• Check to see if food particles are in glass
trap. (See Care of Glass Trap Filter, page 15).
• Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
19).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2 Do not add detergent.
3 Select the HEAVY WASH cycle. Press START/
CANCEL pad and close door.
4 Allow 1/2 hour for the dishwasher to begin the
main wash. Open door and pour 2 cups of
white vinegar into the bottom of the
dishwasher.
5 Close and latch door and allow cycle to
finish.
NOTE
If these conditions persist, a home water
softener should be considered.
ERROR CODES
In certain situations which are critical to machine
function and safe operation, the control will shut
down. All lights on console will illuminate.
Er 01
Leak Detector - Water detected in the pan under
the tub.
Er 02
Thermistor - Failed thermistor/turbidity module.
Er 03
Wash Pump - Wash pump not operating
Er 06
Lower Fan - The control board did not receive
proper speed feedback from the lower fan
Er 08
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Er 09
Communications - Communication failure be-
tween main user board and power supply
Er 10
Mains Relay - Failure in the mains power relay
Er 13
System wide - Lost control of the State Machine
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
18).
REMOVING SPOTS AND
DISHWASHER HAS AN ODOR
FILM
Solutions to Common Problems
Er 15
Fill Valve - Water inlet valve is leaking
Er 16
Float - Float switch is stuck/drain is clogged.