Electrolux EW28BS85KS - Manual (Page 12)

12 Removing the Doors
Once both doors are in place, ensure they are aligned
with each other and level (Please see the
Installation
section for more details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.
NOTE
You will be pulling approximately five feet of water
tube from the back of the refrigerator.
Lower Hinge Removal
To reinstall the right door, reverse the above steps.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides
(two screws on each side).
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are
fully inserted into slots on each side.
CAUTION
Drawer is heavy. Use caution when lifting.
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
2 Reinstall four drawer screws (two per side),
tighten down, and close drawer (C).
Push
Against
Freezer
Drawer
Grab
Drawer
At Center
From
Both
Sides
Then
Pull Drawer
Out
A B
Assembly
Pin
Slot
Cabinet
Fully Extend
Drawer Slides
3 Check gasket seal around top, bottom, and sides
of freezer drawer.
4 If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
5 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Install Hex
Head
Drawer
Screws
NOTE
When reinserting the water tube and replacing the top
hinge cover, use care to be sure you do not kink the
tube.