Appendix ii – Albatron Technology PX845PEV-800 User Manual
Page 48
Albatron Anniversary Special Edition PX845PEV-800
45
Appendix II：
This mainboard complies with the ATX standard, which means the ACPI connector on this
board is 2-pin. If the Power LED cable of your case uses a 3-pin adapter, you must use the
2-pin to 3-pin adapter (contained in the packaging).
Locate the Power LED cable attached to the case. If the Power LED cable has a 3-pin
adapter, you must use the 2-pin to 3-pin adapter which comes with the packaging.
The heads of the power cables usually have a triangular mark which indicates the positive
electrode(+). Connect the 3-pin end of the adapter to the Power LED cable, matching up
the positive electrodes(+).
Finally, attach the 2-pin end of the adapter to the ACPI pins on the mainboard, making
sure you match up the positive electrodes(+).