Albatron Technology PX845PEV-800 - Manual (Page 25)

Albatron Anniversary Special Edition PX845PEV-800
22
Chapter 2. BIOS Setup
Introduction
This section describes PHOENIX-AWARD™ BIOS Setup program which resides in the ROM
BIOS firmware. The Setup program allows users to modify the basic system configuration.
The configuration information is then saved to CMOS RAM where the data is sustained by
battery after power-down.
The BIOS provides critical low-level support for standard devices such as disk drives, serial
ports and parallel ports. As well, the BIOS controls the first stage of the boot process, loading
and executing the operating system.
The PHOENIX-AWARD
TM BIOS installed in your computer system’s ROM is a custom
version of an industry standard BIOS. This means that it supports the BIOS of Intel ® based
processors.
This version of the PHOENIX-AWARD
TM BIOS includes additional features such as virus and
password protection as well as special configurations for fine-tuning the system chipset. The
defaults for the BIOS values contained in this document may vary slightly with the version
installed in your system.
Plug and Play Support
This PHOENIX-AWARD™ BIOS supports the Plug and Play Version 1.0A specification as
well as ESCD (Extended System Configuration Data) write.
EPA Green PC Support
This PHOENIX-AWARD™ BIOS supports Version 1.03 of the EPA Green PC specification.
APM Support
This PHOENIX-AWARD™ BIOS supports Version 1.1 & 1.2 of the Advanced Power
Management (APM) specification. These features include system sleep and suspend modes in
addition to hard disk and monitor sleep modes. Power management features are implemented
using the System Management Interrupt (SMI).
PCI Bus Support
This PHOENIX-AWARD™ BIOS also supports Version 2.2 of the Intel PCI (Peripheral
Component Interconnect) local bus specification.
DRAM Support
DDR (Double Data Rate) SDRAM (Synchronous DRAM) is supported.