Brother FAX-T106 - Manual (Page 47)

Setup Receive
5 - 7
To transfer a telephone call to the fax machine
When you pick up the voice call at the remote DECT cordless
phone and would like to transfer it to the fax machine,
1
Press DECT Activation Voice Code 8 1 at remote cordless
phone.
2
The fax machine rings (pseudo-ring same as current F/T ring)
and the display shows “PICK UP PHONE”.
3
Pick up the handset and press Tel (FAX-T104 only).
—OR—
Just press Speaker Phone (FAX-T106 only) at the fax
machine in order to transfer the voice call to the fax machine.
If nobody answers at the fax machine, pseudo-ringing stops after
30 seconds. In that case, it may still be possible to speak with the
caller from the cordless phone. Speech between the fax machine
and the cordless phone (as with an intercom system) is not
possible.
Changing the remote codes
Remote Codes might not work with some telephone systems. The
preset Fax Receive Code is
5 1. The preset Telephone Answer
Code is # 5 1. The preset Activation Voice Code 8 1.
1
Press Menu/Set, 2, 4.
2
Press
▲ or ▼ to select ON (or
OFF ).
Press Menu/Set.
3
Enter the new Fax Receive Code.
Press Menu/Set.
4
Enter the new Telephone Answer Code.
Press Menu/Set.
5
Enter the new Activation Voice Code.
Press Menu/Set.
6
Press Stop/Exit.
Don’t hang up the call from the cordless phone until the voice
call has been transferred to the fax machine. You will know
when this is because you will no longer be able to hear or talk
to the caller via the cordless phone. If you do not wait until this
point before hanging up from the cordless phone, the call will
be lost.
If you are always disconnected when accessing your external
TAD remotely, try changing the Fax Receive Code,
Telephone Answer Code, or Activation Voice Code to other
three-digit codes using numbers 0-9,
or #.
4.REMOTE CODE