Brother CS8800PRW - Manual (Page 27)

25
1
———————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
Memo
● When sewing with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
a Spool cap (small)
b Spool (cross-wound thread)
c Space
h
While holding the spool with your right hand,
and then pass the thread under the thread
guide.
a Thread guide
i
Pass the thread under the thread guide cover
from the back to the front.
Hold the thread with your right hand so that
there is no slack in the thread that is pulled
out, and then pass the thread under the thread
guide cover with your left hand.
a Thread guide cover
j
Feed the upper thread as shown in the
illustration below.
k
Make sure you guide the thread through the
thread take-up lever from right to left as
shown in the illustration below.
a Thread take-up lever
Memo
● If the needle is not raised, the thread take-
up lever cannot be threaded. Be sure to
press the needle position button to raise the
needle before threading the thread take-up
lever.
a
c
b