Brother PT-P750W - Manual (Page 3)

1
Unpacking the PT-P750W and Parts
Description
Check that the package contains the following before using the P-touch labeler. If any
item is missing or damaged, contact your Brother reseller.
2
Setting the Tape Cassette
3
Connecting the Power Supply
Using the AC adapter
Using the batteries
To remove the batteries, reverse the installation procedure.
4
Turning the P-touch labeler On or Off
On: Press the Power button.
Off: Press and hold the Power button until the Status lamp is lit in orange.
5
Creating a Label using P-touch Editor
Lite
1.
Turn on the P-touch labeler ( 1), then press and hold down the Editor Lite button
until the green Editor Lite lamp lights up ( 2). Connect the USB cable to the
computer and PT-P750W.
Brother Support website
support.brother.com/g/d/d5p2/
Please visit our Support website.
You can find following information:
• Software download
• Manuals/Documents
• Frequently Asked Questions (Troubleshooting, Useful tips on using printer)
• Consumable information and the latest OS compatibility information.
You can also see setup steps on the website.
Click the "Getting ready to use your printer." link in the "information" section.
The contents of this website are
subject to change without notice.
• PT-P750W • AC adapter (AD-E001) • USB cable
• Starter tape cassette
1 Top panel
2 Editor Lite lamp
3 Editor Lite button
4 Wireless mode button
5 Tape exit slot
6 Wi-Fi lamp
7 NFC lamp
8 Feed & Cut button
9 Status lamp
10 Battery lamp
11 Power button
12 Battery cover
13 Mini-USB port
14 AC adapter connector
15 Cassette cover
16 NFC tag
17 Release lever
18 Print head
19 Tape cutter
20 Cutter blade
CAUTION
If you cannot close the cassette cover, check to ensure the white lever is in the
up position. If not, lift the lever, and then attach the cover.
NOTE
• Make sure that there is no slack in the tape.
• When setting or removing the tape cassette, make sure that the tape does not
catch on the protrusion (1) or the print head.
14
13 15
5
3
4
1
2
8
9
11
12 17
18
19
20
10
6
7
16
1
CAUTION
• Remove the batteries if you do not intend to use the P-touch labeling system
for an extended period of time.
• Dispose of the battery at an appropriate collection point, not in the general
waste stream. In addition, be sure to observe all applicable federal, state, and
local regulations.
• When storing or discarding the battery, wrap it (for
example with cellophane tape), to prevent it from
short-circuiting.
(Battery insulation example)
1. Cellophane tape
2. Alkaline or Ni-MH battery
NOTE
When turning the P-touch off, keep the AC adapter connected or the batteries
installed until the Status lamp goes off.
AD-E001
LR6 or HR6
2
1
2
1
ELECTRONIC LABELING SYSTEM
English
User’s Guide
Printed in China
LAE838001
Español
PT-P750W
Read this guide before you start using your P-touch labeler.
Keep this guide in a handy place for future reference.