Brother PE-DESIGN Ver.7 - Manual

1
■ Windows ®
Vista users
Windows
®
Vista users should perform the installation
according to the following information, “Step 1:
Installing the Software”. In addition, when updating
the software, perform the procedure described in
“Checking for the Latest Version of the Program” on
page 4 of this insert.
■ Windows ®
2000 and XP users
Windows
®
2000 and XP users should perform the
installation according to the procedure described in
the Quick Reference Guide.
However, the procedure described in “Step 2:
Installing the Driver for the Card Writer Module” in
the Quick Reference Guide is unnecessary. (The
card writer driver will be installed automatically
during the procedure described in “Step 1:
Installing the Software”.)
The following procedure should be performed by a
user with Administrator privileges.
Otherwise, the administrator password may be
requested during the procedure. Type in the
password to continue the procedure.
Step:1
Installing the Software
This section describes how to install the application
software.
→ After a short while, the Auto Play dialog
automatically appears.
IMPORTANT:
READ BEFORE USE.
Vista Installation Instruction
and
Update to Quick Reference Guide
This information applies to the Ver. 7.02 or later.
a
Note:
•If the installation is interrupted or not
performed as described, the software
will not be installed correctly.
•Before turning on the computer, be sure
to DISCONNECT the USB card writer
module.
Insert the enclosed CD-ROM into the
computer’s CD-ROM drive.
Click Run setup.exe.