Brother CM550DX - Manual (Page 9)

9
From the center to the outside, sew symmetrically in
the order shown in the illustration.
1 Beginning of stitching
1
Insert the needle a short distance from the
beginning, and then pull the thread to bring
the knot between the top and backing fabric
in order to hide it.
2
At the beginning of stitching, sew one
backstitch.
Be sure to pass the needle through the three
layers (top, quilt batting and backing fabric)
when quilting.
1 Backstitch
1
Sew one backstitch, make a french knot, and
then insert the needle into the same hole
again to bring the knot between the top and
backing fabric in order to hide it.
2
After quilting and removing the basting
stitching, cut off the excess backing fabric and
quilt batting, leaving for the bias tape a
finished width of 7 mm (1/4 inch) from the
edge of the top (patchwork).
1 Top (patchwork)
2 Cut off, leaving for the bias tape a finished width
from the edge of the top.
7 Quilting
Quilting order
Beginning stitching
1 Start of quilting
2 2 to 3 cm (3/4 to
1-3/16 inches)
3 Quilting lines
4 Thread knot
5 The thread knot is
inside.
(3)
(3)
(3)
(3)
(4)
(4)
(4)
(4)
Ending stitching
1 Backstitches
2 Thread knot
3 Top 4 Quilt batting
5 Back of fabric
6 French knot
1
2