Autostart AS-6205 - Manual (Page 3)

Basic Remote Operation
This system is equipped with a 5-button multi-channel two-way transmitter. It can operate
two independent identically-equipped vehicles (see Multi-Car Operation for second-car
transmitter functions).
The functions of the transmitter are as follows:
Note: Pressing the LOCK and UNLOCK buttons at the same time will activate the AUX 2 output.
Remote-starting Your Vehicle
Remote-starting
Press the
START
button for approx. 1 second. The parking lights will come
ON
, informing
you that the unit has received your signal. The engine will start approx. 5 seconds later.
The parking lights will remain
ON
during the pre-programmed run time.
If the vehicle doesn’t start at the first attempt, the system will shut down, wait a few
seconds, and try to start the engine again. It will try to start the engine 3 times before
giving up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in
preparation for the next remote start. Settings for the blower motor (fan), front and rear,
as well as heated seats (if equipped) should not be left on
HIGH . It is recommended to
leave the settings on LOW or MEDIUM instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are
OFF . Leaving the headlight
switch ON on certain vehicles could cause them to remain ON even after remote starter
shut down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to
DISARM
and
UNLOCK
the doors. Enter the vehicle and do the following:
P. 3 User Guide AS-6205 SH