Ameriphone RC-100 - Manual (Page 15)

CHAPTER 7
(CONTINUED)
CHANNEL SETTINGS
The DIALOGUE RC and Remote
Transmitter use radio signals to
communicate with each other. For the
Remote Transmitter to activate the
DIALOGUE RC , they both have to be
on the same "channel." A "DIP Switch"
is used for channel selection.
Your phone and remote have been preset
at the factory to a standard channel
setting. Under normal operating condi-
tions, there is no adjustment necessary.
If your system encounters interference
and repeatedly activates by itself for no
obvious reasons, it may be necessary to
change DIP Switch settings on the
DIALOGUE RC and Remote Transmitter.
1. Unscrew bottom of the Remote
Transmitter.
2. Locate DIP Switches on Remote
Transmitter and on bottom of
DIALOGUE RC .
3. Using a ball point pen, change the
settings on all switch positions to
match exactly on both
DIALOGUE RC
and Remote Transmitter.
4. Replace remote cover and test.
Figure 24 – Channel setup
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
S
E
T
T
O
M
A
T
C
H
E
X
A
C
T
L Y
13
(Remove cover to
expose switch)