Ameriphone RC-100 - Manual (Page 14)

CHAPTER 7
IN CASE OF DIFFICULTY
If any problem should occur during operation of your DIALOGUE RC , review the list below.
Should the difficulty persist, contact AMERIPHONE or your authorized dealer before sending
the phone for service.
SYMPTOM
No dial tone
No power
Does not dial out
Does not dial memory number
Remote Transmitter does not work
No audible ring
Does not scan through memory
Scanning too fast/slow
Cuts in and out while speaking/
listening
Callers can’t hear your voice when
using the optional headset with
integrated microphone
CAUSE AND REMEDY
– Check all phone line connections.
– Check power connection.
– Check all phone line connections and power
connection.
– Change to pulse dialing and try again.
– No number programmed in memory.
– Check or replace battery.
– Check channel settings.
– Make sure no part of the
DIALOGUE RC
system is on or near metal surfaces or electrical
equipment.
– Make sure the ringer is not set to "Off" position.
– Turn on Scan function.
– Program Scan rate to a slower/faster setting.
(Dialogue RC–200 only.)
– Avoid speaking at the same time as the other
party. Take turns.
SENSITIVITY ADJUSTMENT
YOU MUST CONTACT AMERIPHONE BEFORE MAKING THE FOLLOWING ADJUSTMENT:
12
– Turn HEADSET MIC GAIN adjustment, located
on bottom of unit, clockwise to increase
sensitivity, counterclockwise to decrease.