Help – Audiovox 128-4874A User Manual

Page 7

HEX NUT

PERFORATED STRAP

SCREW STUD

RADIO

EXISTING DASH TRIMPANEL

SCREW

SHAFT NUT

HEX NUT

MOUNTING PLATE FROM KIT
(NOT INCLUDED WITH RADIO)

HELP!

Monday - Friday
Saturday

8:30am - 7:00pm Eastern

9:00am - 5:00pm Eastern

-7-

IMPORTANT

A MOUNTING KIT IS

REQUIRED

FOR THIS INSTALLATION

CHR

CHRY

YSLER-DODGE-PL

SLER-DODGE-PL

SLER-DODGE-PLY

Y MOUTH INST

MOUTH INST

MOUTH INSTALL

ALL

ALLA

TT ION

ION

ALL U.S. MA

ALL U.S. MADE CA

DE CA

DE CARS, TRUCKS, A

RS, TRUCKS, A

RS, TRUCKS, AND VA

ND VA

ND VANS BUIL

NS BUIL

NS BUILT SINCE

T SINCE

T SINCE 1974

1974

Important-This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth vehicle without an
installation kit. Refer to the Kit Listing on Page 1 for the required kit. Complete kit installation is explained in the
instructions included with the kit.

1. Remove the Existing Radio:

A. Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured

by screws and/or snap-in clips.

B. Remove the two large screws used to secure radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.

2. Install the New Radio:

A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied

with the kit.

B. Place the radio near the dashboard so the wires can be led through the opening and following the

instructions of Step 2 on Page 2 and the diagram on Page 8, carefully wire the radio making certain all
connections are secure and insulated and confirm proper operation.

C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut

provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or
below the radio using the screw and nut provided. Bend the strap to position it as necessary.

CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from

the weight of the radio or improper operation of the radio due to vibration.

E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.

1-800-645-4994