Audiovox 128-4874A User Manual

Page 4

HEX NUT

PERFORATED STRAP

SCREW STUD

SCREW

RADIO

MOUNTING PLATE FROM KIT
(NOT INCLUDED WITH RADIO)

EXISTING DASH TRIMPANEL

HEX NUT

SHAFT NUT

CHE

CHEVR

VROLET-OLDSMOBILE-BUICK-PONT

OLET-OLDSMOBILE-BUICK-PONT

OLET-OLDSMOBILE-BUICK-PONTIIIII AC-GMC-CA

AC-GMC-CA

AC-GMC-CADILL

DILL

DILLAC-SA

AC-SA

AC-SATURN

TURN

INST

INSTALL

ALL

ALL A

TT ION - 1982 A

ION - 1982 A

ION - 1982 AND NEWER

ND NEWER

Important-This installation is designed for most 1982 and newer GM cars, trucks, and vans where an installation
kit is required. See Kit Listing on Page 1 of this manual or refer to the in-store application chart. If a kit is not
required, use the instructions on Page 3.

1. Remove the Existing Radio:

A. Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured

by screws and/or snap-in clips.

B. Remove the screws used to secure the radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.

2. Install the New Radio:

A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied

with the kit.

B. Place the radio near the dashboard so the wires can be led through the opening and following the

instructions of Step 2 on Page 2 and diagram on Page 8, carefully wire the radio making certain all
connections are secure and insulated and confirm proper operation.

C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut

provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or
below the radio using the screw and nut provided. Bend the strap to position it as necessary.

CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from

the weight of the radio or improper operation of the radio due to vibration.

E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.

-4-

IMPORTANT

A MOUNTING KIT IS

REQUIRED

FOR THIS INSTALLATION