Trio Motion Technology MC224 - Manual (Page 5)

ADDING
DAUGHTER
BOARDS
A
A
B
B
C
C
C
D
C
C
C
C
C
Unscrew the 2 Allen screws (A) which secure the front moulding
cover and remove the cover.
Unscrew the top ribbon cable bus cover (B). If the ribbon cable is
connected, remove this by pushing the retaining levers outwards.
Unscrew the 8 screws (C) which secure the right hand side cover of
the module.
Unscrew the single screw (D) which secures the axis daughter board
to the left hand side of the module. This is located by the left hand
end of the axis daughter front panel.
The sequence is reversed after inserting any new modules.