Timeguard MLB3000 - Manual (Page 8)

HOLIDAY MODE
Switch the internal wall switch/circuit breaker 3 times (off/on off/on off/on) within 2 seconds.
A single flashing red LeD at the top of the sensor head indicates Holiday Mode.
The unit will now illuminate for a user defined time between 1 and 8 hours. The time can be
set by rotating the centre adjustment knob as required. (See diagram G, the adjustment knob
is identified by the letter T inside a circle.)
Do not adjust this setting if you do not wish to use the Holiday Mode facility.
This time adjustment is factory set to 1 hour.
please note: Fully anticlockwise is 1 hour, fully clockwise is 8 hours.
After the defined period has elapsed, the unit will return to Automatic Mode and operate as
previously set up and the three scrolling LeD's will illuminate from left to right.
Holiday Mode will nOT reset to Automatic Mode at dawn, it will repeat each night until reset
by the user.
To cancel Holiday Mode, switch the internal wall switch/circuit breaker once (off/on) within
one second. The unit will turn to Automatic Mode indicated by the scrolling LeDs.
SECTION FIVE
TECHNICAL SPECIFICATIONS
Detection Range
Detection Angle
Power Supply
Maximum Switchable Load
Time On Adjustment
Dusk Level Adjustment
Environmental Protection
EC Directives
Up to 12 metres
200º
230 V AC ~ 50Hz
3000W Filament/Incandescent
or 500W Fluorescent/Low Energy
5 seconds - 18 minutes
Day & night or night only operation
IP55 (suitable for outdoor use)
Conforms to 73/23/EEC. 89/336/EEC
If you experience problems refer to Troubleshooting Guide.
If problems still exist, do not immediately return the unit to store.
Telephone the Timeguard Customer Helpline
020 8450 0515
Qualified Customer Support Co-ordinators will be on-line to assist in resolving your query.