Timeguard ECO36PIR - Manual (Page 6)

MANUAL OvERRIDE MODE
The light can be switched on for longer time periods by use of the Manual Override Mode.
This can be activated at night by using the internal wall switch or circuit breaker.
Switch the internal wall switch/circuit breaker twice (on/off once) within 1/2 to 2 seconds.
The unit will now illuminate continuously until it is switched back into Auto Mode.
To get switch the unit back into Auto Mode, switch the internal wall switch/circuit breaker
off for 10 or more seconds and then back on again. The unit will return to Auto Mode.
5. TECHNICAL SPECIFICATIONS
Detection Range
Detection Angle
Power Supply
Maximum Switchable Lamp Load
Time On Adjustment
Dusk Level Adjustment
Environmental Protection
EC Directives
Up to 12 metres
Up to 160º
230 v AC ~ 50Hz
36w Low Energy Spiral bi-pin tube*
30 seconds - 7 minutes approx.
Day & night or night only operation
IP44 (suitable for outdoor use)
Conforms to 73/23/EEC, 89/336/EEC
If you experience problems refer to
Troubleshooting Guide.
If problems still persist, do not
immediately return the unit to supplier.
Telephone the Timeguard Customer
Helpline
020 8450 0515
Qualified Customer Support Co-ordinators will be
on-line to assist in resolving your query.
* Should you experience difficulty in obtaining replacement
lamps, these are available from Timeguard Limited, please ring
the helpline number below.
B
Using lamp supplied