Timeguard NTT08 - Manual (Page 9)

8
8.2 Programming across
midnight:
Enter the required programme on time.
Enter the programme off time as 00:00
Enter the first programme on time for
the next day as 00:00
Enter the required programme off time.
Note: for 24 hour the on period for programme 1
must start 00:00.
9. Modifying or adding
programmes:
Press Prg and hold for 3 seconds. Whilst holding,
the word hold will appear on the display.
After 3 seconds the display will show the
programming mode screen. This will be in the mode
in which it was last programmed. for instance if it
was programmed in 5 + 2, then it will show Mo Tu
We Th fr. Either accept this, press Prg, and review
the times programmed for this mode by pressing Prg,
or press Adv/ovr or Boost to change the mode, and
then press Prg to review the times. In this case, either
to Sa Su, or to 7 day or to individual days.
note: If the unit was programmed as a 5 + 2 then
changing the mode to any other mode other than
Sa Su may blank any previous programming.
The same applies for changing from any other mode,
changing from the mode it was last programmed in
may blank the previous programme.
Review times and adjust as necessary as described
in section 8.