Setting or adjusting clock – Timeguard TG77 User Manual

Page 4

5. Setting or Adjusting Clock

Points to remember while setting time or programming:-

(Seconds display is not shown on diagrams for sake of clarity.)
The → and ← buttons alter the days/day combinations, the hours, the

minutes and programme numbers/ON or OFF designation. The ←

button also initiates the programme sequence for Countdown CTD

mode. The → button also initiates the ON/OFF programme sequence

and achieves easy SUMMER/WINTER time change when pressed at the

same time as the TIME button.
The → button increases the above value which is flashing and the ←

button decreases it. If the particular value required is towards the end

of a sequence (eg 52 for minutes) pressing the ← button can get to it

quicker (from the 00 position).
The → or ← button can be held down to provide fast advance or

reverse.
The programming process is achieved by alternate use of the SET and
→ or ← buttons.
The setting sequence is as follows:-

(example used is 10:52 WE being set from a reset condition (see section

4)) If you wish to use the easy Summer/Winter time changeover

described in section 13 please set the time to GMT (Winter time).
Press the SET button for approximately

4 seconds and the day symbol will flash.

Press → until the display shows WE.
Press SET, display shows:

Press → until the hour digits reach 10.
Press SET, display shows: