Sterlco TG 1200 Series Thermoform Granulators - Manual (Page 24)

T-Series Thermoforming Granulators Maintenance 24 of 37
5-6 Motor Drive Belt Replacement
Use the following procedure to replace the drive belts:
1. Turn off the main power and remove fuses.
2. Remove the belt guard to gain access to the belts (See Figure 8).
3. Turn the adjusting screw on the motor slide base to release all tension from the belts.
4. Remove the belts
5. Install the new belts and proceed to adjust the belt tension as instructed in Section 5-5
on page 23.
6. Replace base panels and guards.
7. Replace the line fuses and turn main power on.
Figure 8: Adjusting the Motor Base
Belt
Guard
Motor Slide Base
Adjusting
Screws
Motor Base Slide
Mount Screws
Drive
Motor
Motor Slide Base