AT&T CL82350 - Manual (Page 25)

20
Answering system settings
Message alert tone
When the message alert tone is set to
ON, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it,
the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press q CID or pDIR to scroll to >Answering sys, then
press
MENU
/SELECT.
3. Press q CID or pDIR to scroll to >Ans sys setup, then
press
MENU
/SELECT.
4. Press q CID or pDIR to scroll to >Msg alert tone, then
press
MENU
/SELECT.
5. Press q CID or pDIR to choose On or Off.
6. Press
MENU
/SELECT to confirm your setting. You hear a
confirmation tone. Press OFF/
CLEAR
to cancel.
NOTES:
1. The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
2. To temporarily turn off the message alert tone, see page 42.
> Msg alert tone
-End of list-
MSG ALERT TONE
>On
> Ans sys setup
-End of list-
Play messages
> Answering sys
Telephone settings