Sterlco Midsize - Manual (Page 15)

Portable Hot Oil Temperature Control Units Page 15
Chapter 3: Installation
3-1 Work Rules
The installation, operation, and maintenance of this equipment must be conducted in
accordance with all applicable work and safety codes for the installation location. This may
include, but is not limited to OSHA, NEC, CSA, and any other local, national, and
international regulations.
• Read and follow these instructions when installing, operating, and
maintaining this equipment. If the instructions become damaged or
unreadable, obtain additional copies from the manufacturer.
• Only qualified personnel familiar with this equipment should work
on or with this hot oil temperature control unit.
• Work with approved tools and devices.
• Disconnect the electricity before maintenance or service.
If the unit is installed with a power cord that can be un-plugged,
unplug it. If the unit is permanently wired to a power main, make
sure that a fused power disconnect is installed to allow the
disconnect to be locked in the OFF position. Open and lock out the
disconnect installed in the control enclosure.
3-2 Installation Requirements
Make sure that you meet the following requirements when installing and operating your
portable hot oil temperature control unit.
Installation Location Considerations
Locate the unit as close as possible to the process for proper circulation and temperature
control. Take care when selecting a location. The area surrounding the unit must be free of
obstructions to ensure proper ventilation of internal components. Allow a minimum
clearance of at least 30 inches (76 cm).