ROTRONIC CF5-W - Manual (Page 2)

Dokument
IMA 206 Rev
1 Page
2 (4)
Mounting of the sensor
The wall plate is screwed onto the wall (A) Put the top tabs of the front part into the top
holes of the wall plate.
(B) Press the lower edge of the case onto
the wall plate to latch
If the connection cables are drawn through a conduit the conduit must be
sealed.
Air of different temperature may otherwise disturb the temperature
measurements.
+
~
The top part is pushed under the Terminals and jumpers on CF5-W.
locking hooks of the wall plate The darker positions are default settings.
and is secured with a screw Terminals and jumpers are located under the top part.
If for some reason the PCB must be removed it must be handed carefully
and protected from electrostatic discharge! Normally, removing the PCB is
not required.
A
B
The screw head diameter should be max 7,5 mm
The screw head height should be max 2,5 mm