Aussie 6T01U00SS1 - Manual (Page 7)

7
Connecting LP Gas Cylinder
1. Purchase 1lb. LP Gas cylinder at your local retailer.
2. Turn the regulator knob to the “Off” position.
3. Remove protective cap from regulator opening. Remove plastic cap from top of propane cylinder. Save cylinder cap
for replacement on cylinder if gas remains in cylinder after use.
4. Insert the 1lb. LP Gas cylinder into the threaded hole in the underside of the regulator. Turn the cylinder clockwise
until firmly seated. Hand tighten only. (Fig. 1)
5. For optimum performance, allow cylinder to hang vertically off the edge of the table when there is no danger of
being bumped or disturbed.
NOTE: NEVER FOLD UP OR TRANSPORT GRILL WITH CYLINDER ATTACHED.
Disconnecting LP Gas Cylinder
1. Turn regulator knob to the “Off” position.
2. Remove the cylinder by turning counterclockwise.
3. Replace the protective cap over the regulator opening. Replace the plastic cap on the top of propane cylinder for
storage if not empty.
4. Store cylinder outdoors and away from grill
Hand-tighten Cylinder
in clockwise direction
LEAK
TEST
Fig. 1
NOTE:
If the regulator assembly is not working properly and you need a replacement, contact:
Customer Service at 1-800-251-7558 or go to www.aussiegrills.com. Be sure to have the grill model number
and serial number printed on the label located on the inside surface of the rear leg.
If you need a replacement part under warranty, a proof of purchase will be necessary. You will be asked to
forward your proof of purchase via e-mail or to fax your proof of purchase to 423-639-1055 and reference your model
and serial number. It is important to register your grill and retain your receipt.