Aussie 6T01U00SS1 User Manual

Page 15

5. Use a pipe cleaner to clear insect nests or debris from the inlet hole of Main Burner (Fig. 9)

6. Open up the Burner holes (Fig. 9) with a small nail or wire. Use a non-metallic brush to remove food particles and

corrosion from the Burner surfaces.

Fig. 9

Pipe Cleaner

Open up Main Burner holes

with a small nail or wire.

Valve nozzle

Burner Venturi Hole

fits centrally around

Valve nozzle.

Fig. 10

7. Check the Electrode to see if it is loose. If so, tighten the screw holding the Electrode to maintain 3/16” gap be-

tween Electrode tip and Burner.

NOTE: Before next step, you may wish to clean the rest of the grill. See “Cleaning the Grill” section.

8. After cleaning, refit the Burner. If the grill is to be stored, the Burners may be wrapped in a protective cover such as

aluminum foil or plastic wrap to help keep insects out.

NOTE:

When refitting the Burner, be sure the Burner is positioned correctly. The valve nozzle should protrude inside the

Venturi end of the Burner. (Fig. 10) Replace the Bolts that fasten the Burner Flange to the burner bracket.

9. Perform a Leak Test and check Burner

operation after re-assembly.

10. Replace Flavor Activator and Cooking Grid.