Ouellet OTL3001C - Manual

OTL3001 Printed in China / 06-2012 69-2750EF-02
About your new thermostat
This thermostat is designed to control an electric heating system
such as a baseboard heater or a fan-forced heater.
The thermostat CANNOT be used with:
• a resistive load under 1.25 A
• a resistive load over 12.5 A (120/208/240V)
• a system driven by a contactor or a relay (inductive load)
• a central heating system
Supplied Parts
• One (1) thermostat
• Two (2) screws
• Two (2) solderless connectors for copper wires
Installation
1. Connect the thermostat as shown at the bottom of the page.
2. Remove the thermostat faceplate cover by prying it from the
top or bottom with your fingers.
3. Install the thermostat onto the electrical box using supplied
screws.
4. To limit the setpoint temperature range, insert the pins in the
orifices corresponding to the minimum and maximum tempera-
ture limits.
5. Place the faceplate cover back.
6. Apply power to the heating system.
Technical Specifications
Temperature setting range: 5°C to 27°C (41°F to 80°F)
Operating temperature: 0°C to 50°C (32°F to 120°F) non-condensing
Storage temperature: -20°C to 50°C (-4°F to 120°F)
Customer Assistance
If you have any questions on the product, call our technical support
team at:
Ouellet Canada inc
180, 3rd Avenue
L’ISLET, Quebec, Canada G0R 2C0
Quebec area: 418 247-3947
Canada / U.S.: 1 800 463-7043
Fax: 418 247-7801
Sales: [email protected]
Web: www.ouellet.com
Warranty
ONE (1) YEAR LIMITED WARRANTY
OUELLET CANADA INC. warrants the component parts of the
OTL3001 against defects in material and workmanship for a one (1)
year period from the date of purchase, under normal use and service,
when proof of purchase of such is provided to the manufacturer.
The obligation of Ouellet Canada Inc., under the terms of this
warranty, will be to supply a new unit and this releases the
manufacturer from paying the installation costs or other secondary
charges linked to replacing the unit or the component part(s).
CAUTION: FIRE HAZARD
Special CO/ALR solderless connectors must be used if the
thermostat will be connected to aluminum wires.
WARNING: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect
power before beginning installation. The installation must be
performed by a certified electrician and must comply with
electrical codes of your region.
WARNING: ELECTRICAL HAZARD
Use only the supplied plastic pins. Do not insert metal objects
in the holes.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a
sealed tube, do not place the old control in the trash. Contact
your local waste management authority for instructions
regarding recycling and proper disposal.
Supply Minimum Load Maximum Load
120 VAC, 50/60Hz
208 VAC, 50/60Hz
240 VAC, 50/60Hz
1.25 A (150 W)
1.25 A (260 W)
1.25 A (300 W)
12.5 A (1500 W)
12.5 A (2600 W)
12.5 A (3000 W)
Setpoint range limit pins
Temperature setting knob
Faceplate cover on
Faceplate cover off
Setpoint range limit positions
Two-wire installation Four-wire installation
Mounting screw openings
OTL3001