Ouellet ODS - Manual (Page 3)

180, 3 rd Avenue, L’ISLET, Quebec, G0R 2C0 CANADA
Tel.: (418) 247-3947, 1-800-463-7043 Fax: (418) 247-7801
www.ouellet.com
INSTRUCTIONS
For installation of the
Ceiling Fan-forced Diffuser “ODS Series”
ODSB Model Surface Mounting ( 7.5 to 10 kW)
IMPORTANT
MUST BE INSTALLED SOLIDLY
This heater could weight up to 35 lb (16 kg)
STANDARD CEILING MOUNTING
1. Never install the air-forced diffuser at less than 8 ft. (250 cm)
from
the fl oor and 12 in. (30 cm) from adjacent walls.
2. Provide an exit for the power supply wires in the ceiling,
under the heater.
3. Mount the ceiling support using provided screws.
For drop ceiling mounting, the necessary kit is not provided.
4. Suspend the heater at the hangers of the ceiling support.
5. Convey the wires of power supply to the junction box of
the heater and connect the heater leads to the supply leads
according to the local and national codes.
See wiring diagram.
6. Fold back the heater toward the ceiling and fi x it using
the screw provided..
7. Install the front cover using provided screws (4).
OPTIONS
See installation pamphlet provided with the various options for
the installation of those options.
ATTENTION
Basic precautions should always be followed to reduce the risk
of fi re, electric shock, and injury to persons.
- Read all instructions before using this heater.
- Do not use outdoors.
- Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock, fi re,
or damage to the heater.
- Do not block air intakes or exhaust in any manner.
- Heater contains arcing and sparking parts. Do not use it
in areas where gasoline, paint, or fl ammable liquids
are used or stored.
- Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fi re,
electric shock, or injury to persons.
- Use copper wire only.
- The motor is thermally protected. MAINTENANCE
- Once a year, remove the front cover and use a vacuum
cleaner or compressed air to remove the dust accumulation
inside the heater. Cleaning should be done while the heater is
disconnected from the power supply circuit.
- A qualifi ed technician should perform any other servicing.
WARRANTY
OUELLET CANADA INC. warrants the electric heating
element of the ODSB Series for a ten (10) year period; and its
component parts against defects in material and workmanship
for a one (1) year period following the date of purchase, under
normal use and service, when proof of purchase of such is
provided to the manufacturer. The obligation of Ouellet Canada
Inc., under the terms of this warranty, will be to supply a new
unit and this omits the manufacturer to bear the installation
costs or other secondary charges linked to replacing the unit or
the component part(s).
IMPORTANT
Connect the control (thermostat or relay)
to the T1-T2 position on the terminal block.
Do not interrupt power supply to control this heater.
ODSB (7.5 to 10 kW)
2
1
KEEP THIS INSTRUCTION
FOR THE USER
INS85-200404-03