NUUO SCB-C24 - Manual (Page 15)

The Intelligent Surveillance Solution
NUUO NVR/DVR/Hybrid NDVR System
- 14 -
5.2. Connect C24 to C08
After C08 and server are connected and a COM port is up between them, proceed to connect C24 to
C08.
Connect C08 (TX+, DATA+) to C24 (DATA+). Connect C08 (TX-, DATA-) to C24 (DATA-).
5.3. Connect C24 to Power Supply
Connect C24 to power supply by the power adopter that comes with your purchase.
5.4. Connect Peripherals to C24 & Power Supply
Step 1:
Split a power supply to negative pole and positive pole.
Step 2: Connect the positive pole to C24’s EXT.PWR port.
Step 3:
Connect the negative pole to C24’s EXT.COM port.
Step 4:
Connect the negative pole of each peripheral to C24’s DO (digital output) ports.
Step 5:
Bridge the positive poles of the peripheral devices to C24’s EXT.PWR port.
Fig. 4. Connect Peripherals to C24 &
Power Supply
By the example of Fig. 4, each digital input and output device requires at least 4.0V.
- Input logical level 0: +1V (max).
- Input logical level 1: +4.0V ~ +30V.
5.5. Check C24 COM port, Baud Rate & Address
Step 1:
Run Oconfig.exe on PC.
Step 2:
IOconfig.exe is downloadable at www.nuuo.com > download
Step 3:
Note to close Mainconsole before running IOconfig.exe