Dwyer SC1490 - Manual (Page 2)

949-0531 Rev. 2 Page 2 of 8 December 2004
Getting Started
1.) Using a small screwdriver, ball point pen, etc. set the Input Switch
(SW-1) on the side of the unit for the input range to be used.
2.) Set the Output Switch (SW-2) for the output responses required (see
Output Programming on page 4).
3.) Mount unit into panel. (see Mounting on page 5).
4.) Connect unit to input signal, output signal, and power wiring (see Wir-
ing on page 5).
5.) Check calibration (See Calibration on page 6).
Operation description is on page 6
Specifications are on page 7.
Copyright © 2004 Love Controls Division, Dwyer Instruments, Inc. All rights reserved.