Amerex 05617 User Manual
Page 12
T
ECH
T
IP
Lay hose straight on ground to its full 50' length.
Start first regular loop counter-clockwise by
placing it over the top bracket and between the
side brackets as shown.
The next loop is a regular "hose in front" loop.
Succeeding loops are alternated, reverse, front,
etc. until the full six loops are installed.
The second loop is a “reverse” loop. Note that the
hose passes behind the loop on this reverse coil.
1
2
3
4
< 12 >
®
Adjust loops so that nozzle fits into nozzle mount.
Loops should be approximately the same length.
GUIDE TO PROPER INSTALLATION OF
DISCHARGE HOSE ON WHEELED/STATIONARY
HIGH PERFORMANCE STORED PRESSURE FIRE EXTINGUISHERS
The following installation instructions should be followed to avoid hose
twisting and kinking as the the wheeled extinguisher hose is uncoiled:
HOSE
BEHIND
LOOP