Amerequip 8600 Backhoe - Manual (Page 14)

15
The following locations should be oiled with SAE30
oil:
A. Stabilizer Pivot Pins
B. Control Handle Linkage
C. Seat Bracket Pivot
IMPORTANT: Avoid excessive greasing. Dirt collects
on exposed grease and increases wear greatly. After
greasing, wipe off excessive grease from fittings.
Periodically, check to be sure all bolts and nuts are
tight. See torque chart, page 27.
Lower stabilizers to the ground, extend dipperstick
and bucket and lower boom so bucket rests on the
ground as shown in Figure 6. Refer to these illustra-
tions for the location of all grease fittings.
*IMPORTANT: Before greasing boom to swing frame
pivot (*) shown in Figure 6, raise boom and install
boom safety lock pin shown in Figure 1.
Figure 6 - Lubrication Points
1
1
1
1
1
*
1
1 1
1
1
1 1
2
3
LUBRICATION