Airedale Air Cooled Condensers R407C - Manual (Page 17)

CONDENSERS C11 - 45 / CS50 - 105
Condensers
17
Technical Manual: 6469597 V1.3.0 02_2013
UNIT LIFTING
Horizontal Air Discharge The unit is delivered in horizontal air discharge configuration secured to a pallet. Where
possible the unit should be moved with the pallet in place.
Lift via 4 slings placed over the top corner legs as
indicated
Vertical Air Discharge The unit is delivered in horizontal air discharge configuration secured to a pallet. Where
possible the unit should be moved with the pallet in place.
Before lifting into final position, the unit legs should be re-orientated, instructions for this
are provided at delivery
CAUTION Care should be taken to ensure the unit does not sustain damage before it is lifted
into final position.
> 60°
Lift via 4 slings (provided by others) attached to the lifting
holes provided to the 4 corner legs as indicated
General Employ lifting specialists
Local codes and regulations relating to the lifting of this type of equipment should
be observed
Use the lifting holes provided - Vertical air discharge only
Each chain/sling must be capable of lifting the whole unit
Lift the unit slowly and evenly
CAUTION Only use lifting points provided.
If any other type of slinging is used, due care should be taken to ensure that the
slings do not crush the casework or coil.
CAUTION If the unit is dropped, it should immediately be checked for damage and reported
to Airedale.
SITING RECOMMENDATIONS
Horizontal Air Discharge Avoid where possible siting the unit where wind and air re-circulation may interfere with
the fan operation
A vertical air discharge unit is recommended for installation in windy locations or
wherever a horizontal airflow would be obstructed