Thermo Fisher Scientific CyberComm 5000 for CyberScan Series 5000 - Manual (Page 4)

1 DATA ACQUISITION IN WINDOWS VERSION
1.1 The CyberComm 5000 Data Acquisition Software
The CyberComm 5000 Data Acquisition Software (DAS) package is a user-friendly data acquisition package
that provides a convenient way to capture data for future analysis. This CyberComm 5000 is only able to run
on Windows
©
Operating System (refer to 1.2 System Requirements for details). Communication between
your meter and PC is bi-directional as the meter functions can be remotely controlled by the DAS. Data type
stored is in the ASCII format.
©
Windows is the registered trademark of Microsoft Corporation
1.2 System Requirements
To run the CyberComm 5000 Data Acquisition Software, the following items are required:
1 IBM Compatible PC Pentium and above
2 Windows Operating Systems 95 and above
3 VGA/SVGA Monitor with minimum 800 X 600 resolution
4 RS232C Serial Communication Cable
1.2.1 Setting the Communication Parameters
The meter is capable of different communication configurations for baud rate, parity and stop bits. The
values chosen for these parameters of the meter must match those chosen for the computer, same goes for
the serial printer if it is connected.