Techne TC-4000 - Manual (Page 45)

43
Controller reset
The 'Controller reset' will delete all saved
programs from the unit.
Highlight 'Controller reset' then press
"Enter"
To delete all the programs, press "Enter"
RUNNING THE TC-4000 FROM A PC
The TC-4000 can be run from a PC using Techne’s Gensoft software. This is available to download from
the Techne web-site at www.techne.com. You will need 'Winzip' (which is available free of charge on
www.winzip.com) to unzip the files. Instructions for using Gensoft are included in a separate manual.
CONNECTING ONE UNIT TO THE COMPUTER USING AN RS232 CABLE
If you are driving one TC-4000 unit you will need part number FGEN232 which includes a cable, Gensoft
on disk and an instruction sheet.
Program defaults
Settings
Passwords
Controller reset
CONTROLLER RESET
This will delete
all programs
[ SURE ? ]
[ Yes or No ]