Techne TC-4000 - Manual (Page 42)

CONFIGURATION
Password pad
[ to accept ]
40
Program Information
INFORMATION
CONFIGURATION
Warning! The Configuration software should only be accessed by designated personnel, as some
parameters can be changed or may be lost when using it.
Pressing "Enter" while a program is
running will give information about the
current run including which program is
actually running and the unit status e.g.
holding or ramping.
An example is shown here.
The Information field on the front screen
contains all the unit-specific information such
as serial number and software version.
Press "Enter" to access the unit
information.
The complete list is displayed here.
Note that the "Comms address" must be
unique for each unit if more than one cycler is
linked to a PC using the Gensoft control
software.
The Configuration field on the front screen
allows a system administrator access to set up
all the default settings for the programs, time
and date settings and to change and remove
passwords.
Access to the 'Configuration' set up is
password protected.
To enter configuration, use the alpha keys to
type in 'pad'
Press "Enter"
Programs [0]
Information
Configuration
[ , to select ]
Block 96x0.2ml
Block s/n 139160-2
Unit s/n 131625-1
S/w version 33.01
H/w version 1
Comms address 1
Unit cycles 624
Block cycles 69
DONNA
Heated Lid on
Status ramping
[ to exit ]
Programs [0]
Information
Configuration
[ , to select ]
[ to exit ]