Techne RS232 - Manual (Page 23)

D B - 2 D w i t h R S 2 3 2 O P E R A T O R ’ S M A N U A L
P A G E 21
Operator Maintenance
NOTE THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED
BY PROPERLY TRAINED PERSONNEL. REMOVING THE SIDE,
FRONT OR REAR PANELS EXPOSES POTENTIALLY LETHAL
MAINS VOLTAGES. THERE ARE NO OPERATOR MAINTAINABLE
PARTS WITHIN THE EQUIPMENT.
In the unlikely event that you experience any problems with your Dri-Block
® which cannot easily be remedied, you should contact your supplier and
return the unit if necessary. Please include any details of the fault observed
and remember to return the unit in its original packing. Techne accept no
responsibilty for damage to units which are not properly packed for
shipping: if in doubt, contact your supplier.
1. Cleaning
Before cleaning your unit ALWAYS disconnect from the power suppply and
allow to cool below 50° C.
Your Dri-Block
® can be cleaned by wiping with a damp soapy cloth. Care
should be exercised to prevent water from running inside the unit. Do not
use abrasive cleaners.
2. Fuses
Your unit is protected by two fuses. These should only be changed by
suitably qualified personnel. If the fuses blow persistently, a serious fault is
indicated and you may need to return the unit to your supplier for repair.
230V 2 x F2A; 120/100V 2 x F4A
Replacement Parts
The following parts may be obtained from your Techne dealer if
replacements or alternatives are required:
Part Number Description
6101308 Extraction tool
FCABLEUK Mains cable with 13amp UK plug (5 amp fuse)
FCABLEEU Mains cable with R/A Schuko plug
FCABLEUS Mains cable with 3 pin US plug
FMW11 Techne HI-TEMP 96 TM well plate, pack of 25
FMW12 HI-TEMP 96 TM well cover, pack of 50
F4466 Plastic half block