SUOMY F1 - Manual (Page 7)

ENGLISH
Painting must not contain diluent because it could damage the structure of the
helmet or the layer of the original coating.
The paintings used must dry at room temperature. In any case the helmet and
its components must not be submitted to high temperature to dry.
The surface of the helmet is covered by an anti-fire coating and the use of
not suitable painting can compromise the flame-resistant properties of the
helmet itself.
GENERAL INSTRUCTIONS 06
MAINTENANCE
To clean the shell, use water and neutral soap only. Make the helmet dry at
room temperature. Never expose to heat sources.
Cleaning the helmet with solvents, petroleum derivates or chemicals or
applying adhesive or paint could damage the structure or the shell or peak.
This may affect the safety characteristics without being visible to naked eye.
Never apply paints, adhesives, petrol or other chemical solvents to the helmet.
In case of repainting, please refer to the instructions on page 05.
To clean the inside liner, use a wet cloth and neutral soap only. Make the wet
parts dry at room temperature out of direct sunlight and without exposing to
heat sources.
Wash the polycarbonate visor with water at room temperature and neutral soap
only; dry it with a soft cloth.
When you clean the visor be careful not to damage the surface (antiscratch
and mist retardant) coatings. For cleaning purposes users should not use
petrol chemical solvents, cleaning agents or scouring powders. The structural
strength of the polycarbonate material could damaged by any of these
materials with possibility of loss of optical clarity and mechanical resistance.
Clean the D-ring retention system regularly with warm water and neutral soap.
Do not use solvents or chemical detergents. Do not lubricate.
Some colours are produced with UV Fluo paint. This may be subjected to
natural migration leading to a reduction in brightness. This phenomenon may
be accentuated when the helmet is exposed for long periods to particularly
bright light. However, this does not compromise the performance or quality of
J12. Should this arise, Suomy disclaims all responsibility.
To guarantee reliability, safety and compatibility with the helmet, fit only
original Suomy spare parts and accessories or those suggested by Suomy
Spa for the model of helmet concerned.
Using other than original components and / or accessories invalidates the
guarantee (see guarantee terms on page 16) and may reduce the safety
specifications.
SPARE-PARTS