Spectrex 20/20F - Fast UV/IR Flame Detector - Manual (Page 43)

Spectrex Inc. - SharpEye TM UV/IR (F) Flame Detector Manual – TM756100 Rev A, July 2005
37
Battery Charging
1 The Fire Simulator uses NiCad batteries as a rechargeable power source.
When the batteries are fully charged it will operate for at least 60 uses without
recharging.
An internal buzzer is sounded when the voltage from the batteries is lower
than the required operational level.
2 Place the Fire Simulator into the storage case on a table in a safe area.
3 Turn the sealed plug (next to the operation button) counter clockwise with a
suitable wrench.
4 Connect the battery charger.
5 Charge for a maximum of 14 hours.
6 Disconnect the charger.
7 Tighten the sealed plug clockwise.