NSi Industries ELC712 - Manual (Page 21)

19
Press the +/- keys to select a channel . The current event
for this channel is shown below the channel # (e .g . ON,
OFF, dUR2, CYC4, SC03, NONE) .
Press the OVERRIDE key to toggle the channel status
until the next event . Press the PROGRAM key then the
RUN key to cancel an override (this will not work for
timed external overrides) . To exit the override mode
without making a change, press the PREVIOUS or
NEXT key to return to the override header, then press
the RUN key .
RUN
The RUN mode is the normal operating mode . In the
RUN mode the current time and day are shown . If today
is a holiday, the active holiday schedule is also shown .
Channel status is shown on the bottom line . The channel
number is shown if that channel is on . If the channel
number is flashing, that channel is currently overridden .
If it is flashing mostly on, the channel is overridden on .
If it is flashing mostly off, the channel is overridden off .
The input # is also shown along with the status of that
input . The following is a list of the possible input status
messages:
Message Input Config Status
NONE not config --
On\d On\d input closed
OFFd On\d input open, in delay
-N- On\d not active
OVd OVR overridden on w/
delay
?-V- OVR not active or
overridden on or off
without delay
ENb ENb input closed (enabled)
dISb ENb input open (disabled)
072F sensor, F sensor value