NSi Industries DZS100BP - Manual (Page 7)

10.1 NOTES:
1. Unit will go to RUN MODE automatically if no
key is pressed for 5 minutes.
2. Unit has a look back feature. If you have just fin-
ished setting the unit and an output is to be
updated, press the EVENT key. Unit will auto-
matically pick up the last schedule.
3. Clear all memory. To clear all memory, while in the
RUN mode, press E N T E R, display will show :
Press EVENT, the display will show:
Press ENTER briefly and everything in the timer
memory is wiped off including real time and
date. 12HOUR will flash.
11.0 COPY PROGRAM SETTINGS TO ANOT H E R
MEMORY MODULE (FOR BP MODELS ONLY)
WARNING: DO NOT USE UNIT AS COPIER WHILE
PROGRAM SETTINGS ARE ACTIVE. DOING SO WILL
TURN OFF ANY CONNECTED LOADS.
Follow steps below:
-
Take unit out of enclosure
- Locate the copy switch (red switch labeled BP01)
- Put the switch on the ON position
- Place unit back in enclosure
- Connect power cord
- Put back insulator that covers the terminal block.
Make sure no terminals are exposed to the operator.
- Apply AC power to unit
- Insert the pin in the small pinhole (located in the
upper right hand corner) to reset the unit.
12
If daylight savings is required, press ENTER, dis-
play will show:
Press ENTER to accept default dates (second
Sunday in March) or press MONTH, DATE, and
DAY to modify DST settings and press ENTER. The
display will show:
Press ENTER, the display will show:
Press ENTER to accept default dates (first Sunday
in November) or press MONTH, DATE, and DAY to
modify DST settings and press ENTER. Press
MODE, the display will show:
NOTE: DST OFF indicates Daylight Savings Time
was not set.
4.0 SEASON DURATION SET Up to 4 different season
durations can be set by entering the START and
END dates.
5
DTS100B - DZS100BP 3/8/07 9:28 AM Page 13