MAGURA eLECT - Manual (Page 6)

THE PASSION PEOPLE
www.magura.com
Synchronising the eLECT remote control [ F ]
) Press and hold the button on the eLECT unit for at least 8 s.
О О
LED of the eLECT unit lights up (——).
) Press and hold the button on the remote control for at least 5 s.
О О LED of the remote control lights (——) red.
О О
Synchronisation is performed.
О О
LED of the eLECT unit flashes 3× quickly (0.5 s) and
LED of the remote control flashes 4× quickly (0.5 s) green.
О О Synchronisation is completed.
Calibrating eLECT [ g ]
L L The system must be calibrated before your eLECT can operate
correctly. Different positions of your bicycle during the calibration
(e.g. -1.5°/0°/+1.5°) enable you to preset the responsiveness of
eLECT according to your requirements.
L L If you switch off your eLECT unit (OFF), DLO² remains in its current
status – activated or deactivated.
The following steps must be performed before calibration:
О О
– see t
Aking the e
Lect
into operAtion
, page 5.
О О 
– A djusting the suspension ( Air pressure ) .
О О  – A
djusting the dAMping
(
rebound dAMper
) .
О О
Rear frame suspension and inflation pressure matched to one another.
) Switch on eLECT (ON) or perform a reset if eLECT was already switched
on.
) Move your bicycle to a neutral position (0°).
) Press and hold the button on the eLECT unit for 3–5 s.
О О
LED of the eLECT unit lights up (——)
О О Calibration is performed.
О О LED of the eLECT unit flashes 2× quickly (0.5 s).
О О
Neutral calibration (0°) is completed.
L L If you would like to preset eLECT more accurately according to your
requirements, you should now take a test ride on a representative test
route, and conduct several calibrations if necessary.
Proceed stage-by-stage until the responsiveness of your eLECT corre-
sponds to your requirements.
At each stage, it is recommended that the front or rear wheel of your
bicycle should be raised by 1–2 cm in each case. Use corresponding
wooden boards to increase the height.
) Move your bicycle to a negative position (e.g. -1.5°).
) Perform the calibration as described above.
О О eLECT activates DLO² on relatively slight inclines or even when riding
on the flat.
or:
) Move your bicycle to a positive position (e.g. +1.5°).
) Perform the calibration as described above.
О О
eLECT only activates DLO² on steeper inclines.
For more:

– L ocking out the suspension fork – dLo² .
Performing an eLECT reset
) Switch off the eLECT (OFF).
) Leave the eLECT switched off for at least 10 seconds.
) Switch on the eLECT (ON).