Dlo²/a – MAGURA eLECT User Manual
Page 4
THE PASSION PEOPLE
www.magura.com
Welcome to the PASSION PEOPLE!
You have purchased the MAGURA eLECT retrofit kit to add electronic
controls to the Dynamic Lockout (DLO² – from the 2011 model year)
of your MAGURA suspension fork.
You can check that your suspension fork is suitable for eLECT by the DLO²
or Albert Select+ rotating dial
[
A
]
.
Other MAGURA compression damping systems (DLO³, Albert SL etc.)
must not be replaced with eLECT!
Please read these instructions carefully before you use your MAGURA
product. Always observe and follow all instructions in the owner‘s manual
of your suspension fork.
Never overestimate your technical capabilities. Commission a specialist
workshop for bicycles or an authorized MAGURA service centre with all
installation and maintenance work. This is the only way to ensure that
work is conducted in a professional manner.
Failure to observe the instructions in these user instructions can lead to
serious or fatal accidents.
Keep these mounting instructions for other users of your MAGURA
product.
Visit
www.magura.com for more tips and information on your MAGURA
product. You can also exchange experiences, ask questions and generally
“talk shop” with many PASSION PEOPLE members on the MAGURA
Forum.
We wish you great success and a great ride
Your MAGURA Team
L
egend
)
The pointing finger prompts you to perform an action.
О
О
The arrow shows results or requirements.
L
L
This notice gives you additional information or tips.
This symbol refers to the corresponding chapter of the owner‘s manual of
your suspension fork.
This notice warns you about a dangerous situation which can lead to
serious or fatal injury if not avoided.
This notice warns you about the risk of material damage.
L
L
The following instructions describe the assembly and setup of the
eLECT unit and the eLECT remote control. You will need to download
the „Suspension Fork“ owner‘s manual (from the 2014 model year) with
all other information on eLECT in PDF format at
www.magura.com if
you have an older version or no manual!
r
eMoving
dLo²/A
Lbert
s
eLect
+
[
B
]
Oil loss from opened suspension fork.
Î
–
Make sure that the suspension fork is fixed in an upright position while
replacing the DLO units to ensure that the oil does not flow out of the
inside of the stanchion.
)
Pull the “Albert Select+” adjusting dial
(
1
)
off in upward direction or
remove the cover on the “DLO²”
(
2
)
by unscrewing counter-clockwise.
)
If necessary, loosen the clamping screw
(
3
)
of the inner cable (RCL²).
)
If necessary, remove the remote control lever and Bowden cable.
)
Unscrew the screws
(
4
)
of the rotating dial
(
5
)
.
)
Remove the rotating dial.
)
Loosen and unscrew the DLO unit at the hexagon
(
6
)
counter-clockwise.
)
Leave the DLO unit to drip-dry before final installation in the stanchion.