KROHNE CORIMASS G-MFM 4085 EEx EN - Manual (Page 2)

2
IMPORTANT!
These instructions should be used in conjunction with the Standard Installation and Operating
Instructions for the MFM 4085 K/F.
If you have not received a copy or require a copy, please contact your nearest Krohne Office or
representative or Product Management in Duisburg, Germany.
Product liability and warranty
The CORIMASS mass flowmeter MFM 4085 is designed for the direct measurement of mass
flow rate, product density and product temperature, and also indirectly enables measurement of
parameters such as total mass, concentration of dissolved substances and the volume flow.
For use in hazardous areas, special codes and regulations are applicable which are specified
in the special ”Ex installation and operating instructions” (supplied only with hazardous-duty
equipment).
Responsibility as to suitability and intended use of our instruments rests solely with the
purchaser.
Improper installation and operation of the flowmeters may lead to loss of warranty.
In addition, the ”general conditions of sale” forming the basis of the purchase agreement are
applicable.
If you need to return CORIMASS flowmeters to KROHNE, please complete the form on the last
page of the Installation and Operating manual and return it with the meter to be repaired.
Krohne regrets that it cannot repair or check your flowmeter unless accompanied by this
completed form.