KROHNE OPTIMASS 3000 EN - Manual (Page 32)

6
TECHNICAL DATA
32
OPTIMASS 3000
www.krohne.com 03/2012 - 4001593001 - MA OPTIMASS 3000 R01 en
Flanges
• DIN flange ratings are based on EN 1092-1 2001 table 18, 1% proof stress material group
14EO
• ASME flange ratings are based on ASME B16.5 2003 table 2 material group 2.2
• JIS flange ratings are based on JIS 2220: 2001 table 1 division 1 material group 022a
Notes
• The maximum operating pressure will be either the flange rating or the measuring tube
rating, WHICHEVER IS THE LOWER! WHICHEVER IS THE LOWER! WHICHEVER IS THE LOWER! WHICHEVER IS THE LOWER!
• The manufacturer recommends that the seals are replaced at regular intervals. This will
maintain the hygienic integrity of the connection.
Pressure / temperature de-rating for all meter sizes / materials, in imperial Pressure / temperature de-rating for all meter sizes / materials, in imperial Pressure / temperature de-rating for all meter sizes / materials, in imperial Pressure / temperature de-rating for all meter sizes / materials, in imperial
X Temperature [°F]
Y Pressure [psig]
1 Hastelloy ® HC22 measuring tube
2 Stainless Steel 316L measuring tube
3 Outer casing
MA_OPTIMASS_3000_en_120315_4001593001_R01.book Page 32 Tuesday, October 23, 2012 10:14 AM