KROHNE DK 32-DK 34-DK 37 EN - Manual (Page 5)

SAFETY INSTRUCTIONS
1
5
DK32 - DK34 - DK37
www.krohne.com 06/2014 - 4000287103 MA DK32-34-37-R05-en
Safety instructions
1.1 Intended use
The variable area flowmeters manufactured by KROHNE Messtechnik GmbH are suitable for
measuring gases, vapors and liquids.
These flowmeters are particularly suitable for measuring:
• Liquids
• Hydrocarbons
• Water
• Chemicals with low corrosiveness
• Saturated steam
• Superheated steam
• Industrial gases
1.2 Certifications
The flowmeter meets the statutory requirements of the following EC directives:
• Pressure Equipment Directive 97/23/EC
• EMC Directive 89/336/EC for instruments with electrical options
• ATEX Directive 94/9/EC for instruments in Ex-areas
And also
• NAMUR Recommendations NE 21 and NE 43 (DK37/M8E)
KROHNE Messtechnik GmbH & Co. KG certifies successful testing of the product by applying the
CE mark.
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and corrosion
resistance of the used materials against the measured fluid lies solely with the operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
DANGER!
In case of instruments which are used in explosive endangered areas please consider the
supplementary installation and operating instructions mentioned in the Ex-manual.
WARNING!
The operator shall bear sole responsibility for the use of the flowmeters with regard to
suitability, intended use and corrosion resistance of the materials used to the process product.
The manufacturer shall not be liable for any damage resulting from improper use or use for
other than the intended purpose.
Do not use any abrasive or highly viscous process products.
CE marking
MA_DK32_34_37_R05_en_287103_PRT.book Page 5 Friday, June 6, 2014 11:42 AM