KROHNE SMARTSENS ORP 8510 EN - Manual (Page 29)

DESCRIPTION OF HART INTERFACE
7
29
SMARTSENS ORP 8510
www.krohne.com 11/2013 - 4002547502 - MA SMARTSENS ORP 8510 R02 en
7.3 Connection variants
The sensor is a 2-wire device with a passive 4...20 mA current output and HART ® interface.
• Multidrop mode is supported Multidrop mode is supported Multidrop mode is supported Multidrop mode is supported
In a multidrop communication system, more than 2 devices are connected to a common
transmission cable.
• Burst mode is not supported Burst mode is not supported Burst mode is not supported Burst mode is not supported
In the burst mode a slave device transfers cyclic pre-defined response telegrams, to get a
higher rate of data transfer.
There are two ways of using the HART ® communication:
• as Point-to-Point connection and
• as Multidrop connection, with 2-wire connection.
INFORMATION!
For detailed information about the electrical connection of the sensor for HART
® , refer to
Connecting with junction box SJB 200 W on page 14.
.book Page 29 Monday, November 18, 2013 4:12 PM