KROHNE SMARTSENS ORP 8510 EN - Manual (Page 17)

OPERATION
4
17
SMARTSENS ORP 8510
www.krohne.com 11/2013 - 4002547502 - MA SMARTSENS ORP 8510 R02 en
Operation
4.1 Calibration
4.1.1 Calibration with PACTware TM
Manual hold
• Start the function calibration calibration calibration calibration in menu mode Quick Setup Quick Setup Quick Setup Quick Setup or Setup Setup Setup Setup.
• Activate the function manual hold manual hold manual hold manual hold to avoid an alarm.
• Select yes yes yes yes.
• Press Next Next Next Next to proceed.
Start calibration procedure
• Set value of ORP solution; Default setting: 468 mV
• Press Next
Next Next Next to proceed.
• Dip the sensor into the ORP solution and wait till the value is stable.
• Press Next
Next Next Next to proceed.
i The measurement of ORP solution starts. After approx.10 seconds and a successful
calibration the following values appear:
Old ORP value in mV
ORP solution in mV
Electrode voltage in mV
New offset in mV
New ORP value in mV
• Press Next Next Next Next to proceed.
• Set the calibration date with DD-MM-YYYY.
• Press Next
Next Next Next to proceed.
i The message Save values? Save values? Save values? Save values? appears.
• Select yes yes yes yes to save the values.
• Press Next Next Next Next to proceed.
• Select no no no no to deactivate function manual hold manual hold manual hold manual hold.
• Press Next Next Next Next to leave the calibration menu.
A ORP calibration is necessary in regular intervals or when installing a new ORP sensor.
If the calibration was not successful, the message Warning! Offset out of range! Warning! Offset out of range! Warning! Offset out of range! Warning! Offset out of range! appears behind
the value New offset New offset New offset New offset.
• Press Next Next Next Next to proceed.
• Set the calibration date with DD-MM-YYYY.
• Press Next
Next Next Next to proceed.
i The message Warning! Offset out of range! Warning! Offset out of range! Warning! Offset out of range! Warning! Offset out of range! appears.
• Press Next Next Next Next to proceed.
i The message Save values? Save values? Save values? Save values? appears.
• Select betweenyes yes yes yes or no no no no.
• Press Next Next Next Next to proceed.
• Select no no no no to deactivate the function manual hold manual hold manual hold manual hold.
• Press Next Next Next Next to leave the calibration menu.
.book Page 17 Monday, November 18, 2013 4:12 PM