KROHNE OPTISENS PH 8390 EN - Manual (Page 20)

4
OPERATION
20
OPTISENS PH 8390
www.krohne.com 03/2012 - 4001930601 MA OPTISENS PH 8390 R01 en
3 or 4
pages,
scrolling
with ↓ or ↑
> 2.5
s
^
B test B test B test B test >
^
B1 sim.process inp.A >
^
B1.1 temperature >
^
For further
information
see function
tables.
B1.5 REDOX/ORP
Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! (for
dual channel version; refer to
pH/ORP sensor documentation
for further information)
B1.7 pH
(for dual channel version; refer
to pH/ORP sensor
documentation for further
information)
B2 sim.process inp.B B 2.1 temperature
B2.5 REDOX/ORP
Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! Only if switched to ORP!
(for dual channel version; refer
to pH/ORP sensor
documentation for further
information)
B2.7 pH
(for dual channel version; refer
to pH/ORP sensor manual for
further information)
B3 simulation I/O B3.1 current out A
B3.2 current out B
B3.3 current out C
B3.6 simulation R3 off
B4 actual values B4.1 operating hours
B4.2 process input A
B4.2.1 temperature
B4.2.2 pH/ORP
B4.2.9 CPU temp. (depends on V
number)
B4.2.11 electrode current (µA)
B4.3 process input B
B4.3.1 temperature
B4.3.2 pH/ORP
B4.3.9 CPU temp. (depends on
V number)
B4.3.11 elctrode current (μA)
B5 logbooks B5.1 status log
B5.2 calibration log
B6 information B6.1 C number
B6.2 process input A
B6.3 process input B
B6.4 SW.REV.MS
B6.5 SW.REV.UIS
B6.6 Electronic Revision ER
↓↑ ↓↑ ↓↑ ↓↑
Measuring
mode Main menu Submenu Parameter
.book Page 20 Monday, March 19, 2012 1:52 PM