KROHNE OPTITEMP ConSoft TT 20-51 EN - Manual (Page 17)

INSTALLATION GUIDE FOR CONSOFT
2
17
OPTITEMP
www.krohne.com 10/2010 - 4001091501 - AD OPTITEMP ConSoft R01 en
2.5 Installing drivers for the USB interface
If you are only updating your ConSoft software, skip this chapter. Your old driver installation is
still valid!
Step 1: Step 1: Step 1: Step 1:
Click on "Install USB interface drivers" 1 in the Setup Menu.
Step 2: Step 2: Step 2: Step 2:
The installation procedure for the drivers will start. Wait until this automatic procedure ends. It
will take a few minutes. Then the window closes and the installation of the interface can
continue.
Step 3: Step 3: Step 3: Step 3:
Drivers for the USB interface are now prepared to be installed.
Step 4: Step 4: Step 4: Step 4:
Connect the USB interface and the installation will complete and be ready to use.
Step 5: Step 5: Step 5: Step 5:
You are back to the Setup Menu.
CAUTION!
Make sure your USB interface is not plugged in before driver installation.
Figure 2-17: Setup Menu
1 Install USB interface drivers
2 Install ConSoft
3 Exit
.book Page 17 Monday, October 18, 2010 12:32 PM