KROHNE OPTISWITCH 5200C Contactless EN - Manual (Page 9)

3.3 Operation
The switching condition of OPTISWITCH 5200 C, 5250 C with
plastic housing can be checked when the housing is closed
(signal lamp). With the basic setting, products with a density
>0.7 g/cm³ (>0.025 lbs/in³) can be detected. The instrument
can be adapted if products with lower density should be
measured.
On the electronics module you will find the following indicating
and adjustment elements:
l
signal lamp for indication of the switching condition (green/
red)
l
DIL switch for sensitivity adjustment
l
Mode switch for selection of the switching condition (A/B)
3.4 Storage and transport
Your instrument was protected by packaging during transport.
Its capacity to handle normal loads during transport is assured
by a test according to DIN 55439.
The packaging of standard instruments consists of environ-
ment-friendly, recyclable cardboard. In addition, the sensor is
provided with a protective cover of ABS. For special versions
PE foam or PE foil is also used. Dispose of the packaging
material via specialised recycling companies.
l
Storage and transport temperature see "Supplement -
Technical data - Ambient conditions"
l
Relative humidity 20 … 85 %
Packaging
Storage and transport tem-
perature
OPTISWITCH 5200 C, 5250 C - with contactless electronic switch 9
Product description
30433
-EN
-060831